Dawn of the Duck

Some 3D prints come out perfect. Others… not so much. We tossed the bad ones in the trash—only to find them gone days later. No scraps. No ducks. Just an eerie silence…

Now they’ve returned. Twisted. Cracked. Undead. This is the Dawn of the Duck—a Jeep duck that refuses to stay buried. 

** DuK's are made from PLA plastic, which can warp in extreme heat. 120-140F heat has shown to cause warping on PLA parts that are under stress, (mounts, arms, thinner parts) These DuK's should not be under any stress, but we urge you to take that into consideration on extremely hot summer days, where car dash locations may reach these temperatures. Our suggested advice is to keep them indoors where moisture, heat and UV rays are not an issue, however, in most cases, they should stand up fine in your car.