We all know 2 cupholders are not enough! We designed a way to add a third cupholder to offset the factory two! Printed from either PLA or high temp PETG, this will exceed 140° interior temperatures. Made from 2 separate parts, the base snuggly fits in the ‘key slot’ and the cupholder itself slides in place with its built in dovetail joint, for easy removal. Have a stick shift and use the E brake often?? No worries! This is reversible and able to work in a similar manor over the passenger seat! (It will sit a little higher due to the proximity of the passenger seat to the cupholders vs the drivers) 75mm inner dimension (approx 3”)
** These come made to order, so please allow a few extra days for production
** DuK's are made from PLA plastic, which can warp in extreme heat. 120-140F heat has shown to cause warping on PLA parts that are under stress, (mounts, arms, thinner parts) These DuK's should not be under any stress, but we urge you to take that into consideration on extremely hot summer days, where car dash locations may reach these temperatures. Our suggested advice is to keep them indoors where moisture, heat and UV rays are not an issue, however, in most cases, they should stand up fine in your car.